Compact transmission line design using a single 10 inch neo driver. It has a forward vent which caters for the lower reflex response and also the termination for the higher quarter wave resonance so that the cone is controlled over a wide frequency range.
This bass guitar speaker will hang with a rock drummer no problem and very suitable for smaller gigs. The speaker is a passive design but we have incorporated an option of sliding in a GK MB200 amplifier (or similar nano sized amplifier making a CTL 10+) in the rear to make the system active for a small increase in depth and weight. The design is capable of controlling speaker movements down to a low B on a 5 string.
Very easy to build using one sheet of 9mm plywood which offers stiffness and low weight. The folded interior is not difficult to construct and offers additional bracing to all the sides. We finished ours in a carpeted black material and plastic corner pieces and hexagonal metal grille for toughness but the custom finish is your choice!
Specification:
Type:
Suggested Speaker:
Cabinet Construction:
Sensitivity:
Usable Frequency Response:
Power Handling:
Impedance:
Suggested Amplifier:
Dimensions:
Weight:
CTL design with front vent.
Neo 10 inch driver with optional tweeter.
9mm plywood, screwed and glued.
97 dB/W
35 Hz to 5kHz / (20 kHz with tweeter)
150 to 250W RMS
8 Ohms nominal
GK MB200 super lightweight amp, up to 200W output
290mm wide, 330mm high and 300 (to 350) mm deep.
5.5 Kgs passive or 7 Kgs with MB200 amplifier installed.